Transferring System Components; Transferring The Fan Tray - Cisco 12404 Installation And Configuration Manual

Chapter 5 Maintaining the Cisco 12404 Internet Router
Disconnecting RP Cables
Disconnecting Line Card Cables

Transferring System Components

Transferring the Fan Tray

OL-11636-01
To remove the RP cables from the RP card follow the instructions in the
"Removing an RP or Line Card" section on page
After you disconnect the cables and the RP cable-management bracket from each
card, carefully pull the cables bundles out of the way until the cables can be
reinstalled on the replacement chassis and reconnected to the RP.
Disconnect the line card network interface cables from each line card as instructed
in the "Removing an RP or Line Card" section on page
After you disconnect the cables and the line card cable-management bracket from
each card, carefully pull the cables bundles out of the way until the cables can be
reinstalled on the replacement chassis and reconnected to the RP or line card.
Transferring components are presented in the following procedures.
Transferring the Fan Tray, page 5-45
•
Transferring the Power Entry Modules, page 5-46
•
Reinstalling the Power Entry Modules, page 5-46
•
• Transferring RP and Line Cards, page 5-47
Transferring the Consolidated Switch Fabric Card, page 5-48
•
Remove and transfer the fan tray assembly from the chassis as instructed in the
"Removing and Replacing the Fan Tray Assembly" section on page
Cisco 12404 Internet Router Installation and Configuration Guide
Transferring System Components
5-32.
5-32.
5-28.
5-45