Table of Contents
Advertisement
Replace a Switch Card
Note
Note
7. Verify that after you've installed MPA, the router is in the NSR-ready state. Use the show redundancy
command as shown in the following example:
Router#show redundancy
Thu Jun
Redundancy information for node 0/RP0/CPU0:
==========================================
Node 0/RP0/CPU0 is in ACTIVE role
Partner node (0/RP1/CPU0) is in STANDBY role
Standby node in 0/RP1/CPU0 is ready
Standby node in 0/RP1/CPU0 is NSR-ready
Reload and boot info
----------------------
RP reloaded Wed May 31 16:03:53 2023: 1 day, 5 hours, 48 minutes ago
Active node booted Wed May 31 16:03:53 2023: 1 day, 5 hours, 48 minutes ago
Standby node boot Wed May 31 16:04:06 2023: 1 day, 5 hours, 48 minutes ago
Standby node last went not ready Wed May 31 16:07:06 2023: 1 day, 5 hours, 45 minutes
ago
Standby node last went ready Wed May 31 16:08:53 2023: 1 day, 5 hours, 43 minutes ago
Standby node last went not NSR-ready Wed May 31 16:06:49 2023: 1 day, 5 hours, 45 minutes
Standby node last went NSR-ready Wed May 31 16:13:26 2023: 1 day, 5 hours, 39 minutes
ago
There have been 0 switch-overs since reload
Active node reload "User initiated chassis reload"
Standby node reload "User initiated chassis reload"
Note
Replace a Switch Card
Warning
Hardware Installation Guide for Cisco 8600 Series Routers
104
1
Slide the back end of the MPA into the open
MPA slot.
3
Pull the tab up.
Tighten the captive screws on the MPA within 10 seconds.
Do not over-torque the MPA captive screws when installing the MPA. Tighten the captive screws on the MPA
to a torque of 9.7 in-lbs (1.09 N-m).
1 21:52:36.811 UTC
ago
After you install an MPA, you can use the show interfaces command to verify the traffic on that MPA.
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Replace Chassis Components
2
Pull the ejector lever towards the MPA.
4
Rotate the captive screw to tighten the MPA.
Advertisement
Table of Contents
