Configuring Network Interfaces - Cisco 12404 Installation And Configuration Manual

Chapter 3 Installing the Cisco 12404 Internet Router
Protocols

Configuring Network Interfaces

GRP Ethernet Interfaces
OL-11636-01
Make a note of all passwords you set, and store that information in a secure
location for future reference.
For complete information on protocol configuration for your router, see the
appropriate software configuration publications, which are listed in
Software Configuration Information and Support, page
This section provides a brief summary of information about configuring the
network interfaces for the RP and the installed line cards by using the setup
command utility or setup command. Once configured, the RP and line cards can
communicate with external networks.
To configure the interface parameters for the RP and installed line cards, you need
to have the following information available:
Interface network addresses
•
Subnet mask values
•
Protocols to be configured
•
To obtain this information, consult your network administrator.
For additional interface configuration information for the RP and each of the line
cards installed in your router, see the configuration note that shipped with the RP
or line card.
The RJ-45 and MII receptacles on the faceplate of the GRP are IEEE
802.3u-compliant interfaces. These IEEE interfaces provide connectivity to
Ethernet networks. You can use one interface or the other, but not both at the same
time.
Cisco 12404 Internet Router Installation and Configuration Guide
Configuration Changes
Cisco IOS
3-87.
3-62