Copying A Configuration File From Rp Dram To A Flash Memory Card - Cisco 12404 Installation And Configuration Manual

Copying a Cisco IOS Software Image
Copying a Configuration File from RP DRAM to a Flash Memory
Card
Step 1
Cisco 12404 Internet Router Installation and Configuration Guide
3-85
To copy the running configuration file from DRAM to a Flash memory card,
follow these steps:
Enter the command for copying a running configuration file from DRAM to a
Flash memory card. The command takes the following form:
copy running-config [slot0:|slot1:]filename
Where:
running-config
[slot0: | slot1:]filename
An example of the copy running-config slot0:filename command follows:
Filo# copy running-config slot0:myfile2
20575008 bytes available on device slot0, proceed? [confirm]
Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
Filo#
In this example, the exclamation points (
Note
copied. The
CCCCC
verifies that the file has been copied correctly.
Chapter 3 Installing the Cisco 12404 Internet Router
Specifies the source of the file to be copied from
DRAM.
Specifies the destination of the configuration file
to be copied (the Flash memory card inserted in
either slot 0 or slot 1) and the name of the new
file.
!!!)
characters signify the calculation of the CRC, which
appear as the file is being
OL-11636-01