Setting/Changing The Target Color By Measurement; Memory Channel - Konica Minolta CA-310 Instruction Manual

1. Setting/Changing the Target Color by Measurement

[Operating Procedure]
When the optional 4-Probe Expansion Board CA-B15 is used
Select the probe no. to which you want to set the target color. The target color can be set independently for each
probe connector ([P1] to [P5]) for each memory channel.
1 Press the key.
The LCD display section will switch to the menu selec-
tion screen.
2 Press the key to open the PROBE selec-
tion screen.
Each time the key is pressed, the screen will switch
in the order PROBE → SYNC → ID Name input →
RANGE → Measurement Speed → Number of Digits →
Calibration Standard→ RS232C Baud Rate → PROBE.
3 Press the key to display the probe no.
you want to select.
key is pressed, the probe no. switches in the order [P1] ... .
Each time the
4 Press the key to confirm the selection.
* By default (factory setting), the instrument is set so that [P1] will be selected automatically when the POWER switch is set to ON( | ).
1
. Press the MEMORY CH
channel where you want to set the target color appears.
2
. Place the measuring probe against the display and take mea-
surement.
3
. While the probe is placed against the display,
press the HOLD key.
The latest measured values will be hold and the HOLD LED
lights up.
4
. Press the key.
The measured color of the display will be set as the target color.
5
. Press the HOLD key to start measurement.
The HOLD LED will go out.
* To view the target color you set, press the MR key.
(For details, refer to page 72.)
* By default (factory setting), x=0.3127, y=0.3293 and Lv=160.0 (cd/cm
for each memory channel.
3,5 1
HOLD LED
and keys until the memory
63
4
2
Menu selection screen
MENU : SELECT
PUSH SPACE KEY
PROBE selection screen
SELECT : PROBE
P1 35881112 A
SELECT : PROBE
P3 35881113
Probe no.
2
) are set
Press the key
until the desired
probe no. appears.

Memory channel

CH01 EXT Ad P1A
[ ]