Selecting The Calibration Standard (Data) - Konica Minolta CA-310 Instruction Manual

3. Selecting the Calibration Standard (data)

This section explains how to select the instrument's calibration standard (6500K, 9300K). Selecting the instrument's
calibration standard will set the calibration standard for CH00 as well as for all the memory channels which have
not been user-calibrated.
[Selecting Method]
1
. Press the
The LCD display section will switch to the
menu selection screen.
2
. Press the
c a l i b r a t i o n s t a n d a r d s e l e c -
tion screen.
Each time the
will switch in the order PROBE → SYNC
→ ID Name input → RANGE → Measure-
ment Speed → Number of Digits → Cali-
bration Standard → RS232C Baud Rate → PROBE.
3
. Press the
Each time the
4
. Press the
The selected calibration standard will be set for CH00 as well as for all the memory channels that have not
been user-calibrated.
* By default (factory setting), the instrument is set so that 6500K mode will be selected automatically when the POWER switch is set to
ON( | ).
* To cancel calibration standard setting, press the
<Notes on Calibration Standard Setting>
● The specified calibration target values will be kept even if the POWER switch is set to OFF (●). The selected
calibration standard will be set for CH00 as well as for all the non-user-calibrated memory channels when the
POWER switch is set to ON( | ).
key.
key to open the
key is pressed, the screen
key to display the calibration standard you want to select.
key is pressed, the calibration standard switches alternately between "6500K" and "9300K".
key to confirm the selection.
key.
PQRS TUV WXYZ
7 8 9
MENU
GHI JKL MNO LOCK
4 5 6
ALPHA
White ABC DEF - SPACE
1 2 3
CAL
Red Green Blue
0 .
ENTER
Menu selection screen
MENU : SELECT
PUSH SPACE KEY
SYNC selection screen
SELECT : STD-DT
6500K
SELECT : STD-DT
9300K
50 50
1
2
3
4
The currently selected calibration
standard will be displayed.
Press the key until the desired
calibration standard appears.