Konica Minolta CA-310 Instruction Manual page 118

From the Measurement Preparation section
When performing measurement using Konica Minolta calibration standard
<Selecting the Calibration Standard> Page 50
Not required in the case of flicker measurement**.
1. Press the key to display the menu selection screen.
2. Press the key to open the calibration stan-
dard selection screen.
3. Press the key until the desired calibration
standard appears.
6500K ←→ 9300K
4. Press the key to confirm the selection.
* The selected calibration standard will be set for CH00
as well as for all the memory channels that have not
been user-calibrated.
*1
<Setting/Changing the Target Color> Page 62
Not required in the case of flicker measurement**.
1. Setting/Changing the Target Color by Measurement Page 63
This method can be used for any memory channels.
3,5 1
HOLD LED
When the optional 4-Probe Expansion Board CA-B15 is used
1 Press the
key to display the menu se-
lection screen.
2 Press the
key to open the PROBE se-
lection screen.
3 Press the
key until the desired probe no.
appears.
4 Press the
key to confirm the selection.
Memory channel
CH01 EXT
[
1. Press the CH and
desired memory channel.
2. Place the measuring probe against the display and
take measurement.
3. Press the HOLD key.
The HOLD LED will light up.
4. Press the key.
5. Press the HOLD key. Measurement will start.
The HOLD LED will light off.
●To set an ID name
●To use the analog display function : *3 <Setting the Analog Display Range>
To the Measurement section
4
2
Probe no.
Ad P1A
]
keys to select the
Page 75
116
Not required in the case of flicker measurement**.
2. Setting/Changing the Target Color by Entering Values
Page 65
This method can be used for memory channel CH00 only.
1 3
When the optional 4-Probe Expansion Board CA-B15 is used
1 Press the
lection screen.
2 Press the
lection screen.
3 Press the
key until the desired probe no.
appears.
4 Press the
key to confirm the selection.
Memory channel
CH00 EXT
[
1. Press the CH
2. Press the key.
CH00 x
3127 3293 160.0
_
Cursor
3. Enter the target color (x, y, Lv).
Ten-key ( to
Key ...................................... The cursor moves in
4. Press the key.
: *2 <Setting an ID Name> Page 118
Page 118
2
4
key to display the menu se-
key to open the PROBE se-
Probe no.
Ad P1A
]
and keys to select CH00.
y Lv P1
, ) ... Used to enter values.
the order
x → y → Lv → x.