Konica Minolta CA-310 Instruction Manual page 74

<Notes on Range Setting>
● The range settings will be kept even if the POWER switch is set to OFF (●). The specified analog range will be
effective when the POWER switch is set to ON ( | ).
● The specified range settings are common to all the probe nos. and memory channels.
● Keys may not be operable if "OVER" is displayed on the LCD display section.
● Never press the following keys during range setting.
Doing so will cancel range setting and activate the mode corresponding to the pressed key.
( 0-CAL , MODE , REMOTE , MR , MEMORY CH
<Digital and Analog Display>
In the case of four-digit digital display, measured values are displayed in four digits with the fifth digit rounded off.
Similarly, in the case of three-digit digital display, measured values are displayed in three digits with the fourth
digit rounded off.
However, the values calculated from the digital display may not match the values displayed in the analog display
section.
, )
72