Wake The Realpresence Touch; Pair A Previously Paired Realpresence Touch And Realpresence Group System; Managing Calls; Place A Call Using Contacts - Polycom RealPresence Group 300 User Manual

Wake the RealPresence Touch

If the RealPresence Touch has been idle for two minutes or longer, you might need to wake the device.
To wake the RealPresence Touch:
» Tap the RealPresence Touch screen. This action also wakes the RealPresence Group system and
displays the last screen that was accessed.
Pair a Previously Paired RealPresence Touch and
RealPresence Group System
If your connection to a paired RealPresence Group system is lost, you need to pair that system again.
To pair to a RealPresence Group system that was previously paired:
1 After the system is unpaired, you might see a "Searching" message. Tap Cancel.
2 On the Recently Paired tab, tap the RealPresence Group system that you want to pair.
The pairing connection begins, and the Home screen displays when the pairing is successful.
Note: Unpairing does not hang up calls
If you unpair from the RealPresence Group system, any current calls on the system are still active.
To hang up the calls, pair to the room system and select
or Remove All.

Managing Calls

There are several ways to initiate calls. The most basic calling tasks include the placing calls, answering
calls, and ending calls.
You can perform all of the functions that are available when making conventional calls, plus you can make
multipoint conference calls, stop and start your video, and more.

Place a Call Using Contacts

You can select an existing contact from a list and dial the participant.
To call using Contacts:
1 On the Home screen, tap
2 Tap a contact in the contact list.
3 To dial the contact, tap
Polycom, Inc.
Place a Call, and then tap Contacts.
. The RealPresence Touch dials the contact.
, then Participants > , and Remove
47