Change The Call Security Level - Polycom RealPresence Group 300 User Manual

To verify the check codes match:
1 Place an encrypted H.323 point-to-point call.
2 Press on your remote control, then navigate to Settings > System Information > Call
Statistics.
3 On the Call screen, touch View Call Statistics.
4 At Call Encryption, locate the 16-digit check code as in the following example:
ABC-123/ab-1234 /1a2b34c99009d66e
5 Verbally verify that the check code is the same at both sites.
6 Do one of the following:
 If the codes match, the call is secure. Proceed with the call.
 If the codes do not match, the call might be compromised. Hang up the call and contact your
system administrator.

Change the Call Security Level

When enabled by your administrator, visual security classification works for SIP calls in a BroadSoft envi-
ronment.
This feature helps participants remain conscious of the maximum level of classified information that can be
safely exchanged in a conversation. After a call begins, the Visual Security Classification indication of the
call displays on all endpoint monitors in the call. During a call, you can override the security classification
and assign a lower security classification level.
While you can change the security level, you cannot raise the it higher than the default setting.
To change the security level while in a call:
1 In the local interface, navigate to Call > Security.
2 From the Security Classification list, select the desired security level.
3 Click Continue to confirm your selection. After the security classification is raised or lowered, a
message displays for five seconds to all video participants. The change is only applicable to the
current call.
Polycom, Inc. 43