Select Eagleeye Director Tracking Type In A Call; Enable Eagleeye Director Tracking In A Call - Polycom RealPresence Group 300 User Manual

To adjust a Polycom EagleEye III, Polycom EagleEye IV, Polycom EagleEye Acoustic, or
Polycom EagleEye Director using the remote control:
1 Select either a near-end or far-end video source to control.
During a multipoint call being hosted by a system in the call, you can adjust a camera only at the far
end that has a current speaker.
2 Press the navigation buttons on the remote control to move the camera up, down, left, or right.
3 On the remote control, press

Select EagleEye Director Tracking Type in a Call

If your administrator has enabled Administration settings for users in the local interface, you can set the
tracking type to use in a call:
● Voice: Moves the view between the speaker and the room during a meeting.
● Direct Cut: Moves the view directly from speaker to speaker.
To select the camera tracking type:
1 Select Settings > Administration > Camera Tracking.
2 For the Tracking Mode setting, do one of the following:
 Select Voice to track the speaker. When another speaker starts talking, the view switches from
the first speaker to the room, then to the next speaker.
 Select Direct Cut to track directly from speaker to speaker. You must recalibrate the left camera
when you select Direct Cut mode.

Enable EagleEye Director Tracking in a Call

If EagleEye Director tracking is enabled, the camera follows the person or people who are speaking.
This tracking action, also called automatic camera positioning, can be manually started or stopped.
You must start camera tracking using the menu before the Mute and Unmute buttons will again affect
tracking. After the call is complete, EagleEye Director returns to its default setting.
Figure 1: EagleEye Director
Polycom, Inc.
to zoom out or to zoom in.
36