Generator Cover - Suzuki FL125S Service Manual

REASSEMBLY
• Reassemble the starter clutch in the reverse order of disas-
sembly. Pay attention to the following points:
• Apply a small quantity of THREAD LOCK SUPER to the
starter clutch bolts.
• Holding the generator rotor with the special tool and tighten
the starter clutch inside hexagon bolts 3 to the specified
torque.
" Starter clutch bolt: 10 N·m (1.0 kgf-m)
+ 99000-32030: THREAD LOCK SUPER "1322"
& 09930-34951: Rotor holder

GENERATOR COVER

DISASSEMBLY
• Remove the generator coil 1, pick-up coil 2 and gromment
3.
• Remove the oil seal 4.
REASSEMBLY
• Reassemble the generator cover in the reverse order of dis-
assembly. Pay attention to the following points:
• Install the oil seal 1 with the special tool.
& 09913-70210: Bearing installer set
#
The removed O-ring must be replaced with a new one
to prevent oil leakage.
• Apply SUZUKI SUPER GREASE "A" to the lip of the oil seal.
* 99000-25010: SUZUKI SUPER GREASE "A"
ENGINE
/ /
/ /
3-50
/ /