Reassembly And Remounting - Suzuki FL125S Service Manual

TORQUE LINK
Inspect the torque link for bend or damage. If any defects are
found, replace the torque link with a new one.

REASSEMBLY AND REMOUNTING

Reassemble and remount the swingarm and pillion footrest in
the reverse order of removal and disassembly. Pay attention to
the following points:
PILLION FOOTREST
• Install the pillion footrest 1 and washer 2.
• Install the pin 3.
• Install the cotter pin 4.
#
The removed cotter pin must be replaced with a new
one.
SWINGARM
• Install the torque link 1 to the swingarm.
• Tighten the torque link nut 2 to the specified torque.
" Torque link nut: 13 N·m (1.3 kgf-m)
• Install the cotter pin 3.
#
The removed cotter pin must be replaced with a new
one.
• Tighten the swingarm pivot nut 4 and pillion footrest bracket
lower bolt 5 to the specified torque.
" Swingarm pivot nut: 57.5 N·m (5.75 kgf-m)
Pillion footrest bracket lower bolt: 55 N·m (5.5 kgf-m)
CHASSIS 5-62