8-79
FL125SDW
• If the ET sensor ohmic value does not change in the propor-
tion indicated, replace it with a new one.
! Engine temperature sensor specification
Temperature
20 °C
40 °C
80 °C
100 °C
$ 09900-25008: Multi-circuit tester set
& Tester knob indication: Resistance (Ω)
%
* Take special care when handling the ET sensor. It
may cause damage if it gets a sharp impact.
* Do not contact the ET sensor and the column ther-
mometer with a pan.
ET SENSOR REMOVAL AND INSTALLATION
• Remove the rear center leg shield. (#5-6).
• Disconnect the coupler 1.
• Remove the ET sensor 2.
• Install the ET sensor in the reverse order of removal.
+ ET sensor: 9 N·m (0.9 kgf-m)
TO SENSOR INSPECTION
The tip-over sensor is located in front of the starter relay.
(#8-64)
Resistance
Approx. 13.0 kΩ
Approx. 6.2 kΩ
Approx. 1.7 kΩ
Approx. 1.0 kΩ