BATTERY
SPECIFICATIONS
Type designation
Capacity
1 Upper cover breather
2 Cathode plates
3 Stopper
4 Filter
INITIAL CHARGING
Filling electrolyte
• Remove the aluminum tape 1 sealing the battery electrolyte
filler holes A.
NOTE:
When filling electrolyte, the battery must be removed from the
motorcycle and must be put on the level ground.
• Remove the caps 2.
NOTE:
* After filling the electrolyte completely, use the removed cap 2
as sealing caps of battery-filler holes.
* Do not remove or pierce the sealed areas 3 of the electrolyte
container.
• Insert the nozzles of the electrolyte container 4 into the bat-
tery's electrolyte filler holes, holding the container firmly so
that it does not fall. Take precaution not to allow any of the
fluid to spill.
FL125S
YTZ3
12 V, 8.0 kC
(2.5 Ah)/10 HR
(3.5 Ah)/10 HR
5 Terminal
6 Safety valve
7 Anode plates
8 Separator (Fiberglass plate)
FL125SD
FTZ5S
12 V, 12.6 kC
ELECTRICAL SYSTEM
6-35