Crankshaft Shim Selection - Suzuki FL125S Service Manual

3-57 ENGINE

CRANKSHAFT SHIM SELECTION

• Degrease the right crankshaft web, shim and inner race of the
right crankshaft bearing.
• Place the removed shim 1 on the right crankshaft.
• Put the plasti-gauge (special tool) 2 cut out about 10 mm on
the shim as shown.
& 09900-22302: Plasti-gauge
• Install the right crankcase and tighten the crankcase screws
and bolts.
• Remove the crankcase screws and bolts.
• Separate the crankcase into 2 parts, left and right, with the
special tool. ($3-22)
& 09920-13120: Crankcase and shaft remover
• Measure the width of compressed plasti-gauge with the enve-
lope scale.
% Crankshaft thrust clearance: From 0.02 to 0.07 mm
• If the thrust clearance is not within specification, select the
proper size of shim.
• The shim size is printed on the shim surface.
• After selecting the proper size of shim, place it on the right
crankshaft.
LIST OF SHIMS
Part number
09181-25051
09181-25052
09181-25053
09181-25054
09181-25055
09181-25056
09181-25057
09181-25058
09181-25059
09181-25060
09181-25061
09181-25062
09181-25063
09181-25179
09181-25181
Shim thickness
0.60 ± 0.02 mm
0.65 ± 0.02 mm
0.70 ± 0.02 mm
0.75 ± 0.02 mm
0.80 ± 0.02 mm
0.85 ± 0.02 mm
0.90 ± 0.02 mm
0.95 ± 0.02 mm
1.00 ± 0.02 mm
1.05 ± 0.02 mm
1.10 ± 0.02 mm
1.15 ± 0.02 mm
1.20 ± 0.02 mm
1.25 ± 0.02 mm
1.30 ± 0.02 mm