End Point; Ｅ Point - FUTABA T6K-V2 Instruction Manual

End point

E POINT
Function
The End Point function adjusts the
left and right servo throws, generates
differential throws, and will correct
improper linkage settings.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
（1 second）
● Select the channel with
the Jog key.
＜ ChannelDisplay ＞
AIRPLANE (2AIL1FLP)
1: AI1（Aileron1）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: FLP（Flap）
6: AI6（Aileron6）
7: AUX
8: AUX
End point
① A channel is chosen by Jog key.
Selection range：CH1-8
Adjust the rate of each direction of the stick and VR by repeating step ① .
0 ∼ 0 ∼
140% 140%
② Select
from the menu with the Jog
key.
（Left ／ Down） （Right ／ Up）
rate display rate display
HELICOPTER
1: AIL（Aileron）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: GYR（GYRO）
6: PIT（Pitch）
7: AUX
8: AUX
② Operate the stick or VR of the selected
channel fully to the left (down) or right (up)
and adjust the rate by pressing the + key or
‒ key.
＋
Servo throw
At 100% setting the servo throw of each channel is about 40°
for channels 1 to 4 and about 55° for channels 5-8.
However, the maximum servo travel for channels 5-8 is about
110%.
*When channels 5 to 6 were mixed by 2 AIL etc, the throw
becomes the same (about 40° ) as channels 1 to 4.
"E POINT"
Select the Left/Right (Down/Up)
with the stick (SW,VR).
GLIDER (2AIL2FLP)
1: AI1（Aileron1）
2: ELE（Elevator）
3: FL3（Flap3）
4: RUD（Rudder）
5: FL5（Flap5）
6: AI6（Aileron6）
7: AUX
8: AUX
−
or
(Common)
③ Open the setting screen by
pressing the Jog key.
● The setting rate of each chan-
nel
MULTICOPTER
1: AIL（Aileron）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: AUX
6: MOD（Mode）
7: AUX
8: AUX
Range：
0-140%
Default：100%
● When you want to re-
turn the set value to
the initial value, press
the + key and ‒ key
simultaneously.
61