Table of Contents
Advertisement
procedure is necessary; otherwise the receiver will not work.
1. Place the transmitter and the receiver
close to each other within 20 inches(half
meter).
Less than 20 inches
2. Turn on the transmitter.
3. Turn on the receiver.
4. Press and hold the Link switch more than
two (2) seconds.
When the link is complete, the LED in
the receiver changes to solid green.
When the ID cannot be read due to the
surrounding environment, try reading it
with the transmitter and receiver antennas
touched.
Solid green
Press and hold
established a link to one of the other transmitters. This
to double check whether your receiver is really under
control by your transmitter by giving the stick input and
then checking the servo response.
37
Advertisement
Table of Contents
