Table of Contents
Advertisement
MDL SEL
Model select（Select ／ RX type ／ Link ／ Reset ／ Copy）
Function
This function is used when calling and copying
model data stored in the transmitter. The selected
model data can also be reset. System changes
Model select（SELE）
The model data of up to 30 models can be stored in the transmitter. This function is used when
calling saved model data.
Receiver selection（RX）
The R3006SB supplied with the transmitter, employs the T-FHSS Air system. When you want to use
an S-FHSS receiver, switch to S-FHSS here. However, the telemetry function cannot be used with the
S-FHSS system.
Link（LINK）
When linking with the receiver, the transmitter is set to the link mode here. The ID number of the
currently linked receiver is displayed.
Data reset （RES）
The model data currently in use can be reset to its initial value. However, it does not Reset other
than the following of a parameter.
[ The function reset in a parameter : TELEMETRY mode, STK POSI ALRM ]
Model copy（COPY）
This is the model data copy function. It is convenient when you want to store model data as backup
or build a number of models with the same data settings.
● The data of the model memory currently in use can be copied to another model memory.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
Model select
RX system
● Select the setting
item with the Jog
key.
52
② Select
（1 second）
Link
Reset
(T-FHSS Air, S-FHSS) matched to the receiver type
and linking with the receiver are also done here.
"MDL SEL"
from the menu with the Jog
key.
(Common)
③ Open the setting screen by
pressing the Jog key.
（Model number：1-30）
● Original data : Model type
Model name
● System（T-FHSS Air or S-FHSS)
● Link receiver ID
If telemetry is used, the receiver
ID is needed.
Advertisement
Table of Contents
