Camber Mixing - FUTABA T6K-V2 Instruction Manual

CMB MIX
Function
This function adjusts the rate of camber
the negative and positive directions. The aileron,
flap, and elevator rates can also be adjusted
independently and attitude changes caused by
camber operation can be corrected.
Attitude changes are compen-
sated for by setting the
amount of elevator movement.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
Sets the amount of
movement when
the VR was turned.
● Aileron 1
● Aileron 6
● Flap 5
● Flap 3
● Amount of compensation
of the elevator when the
camber changed.
● Camber MIX ACT/INH
● Can be set to operate from a
switch. When NULL, it is op-
erated by a VR.
154

Camber mixing

All the wing control surfaces are
lowered and the camber is increased
(lift increases)
② Select
（1 second）
(RT1)：The amount of opera-
tions when VR is turned to the
right.
[CMB MIX ２page] （Currently selected condition）
WING TYPE 1AIL
Turn the VR
Attitude changes are compen-
sated for by setting the
amount of elevator movement.
"CMB MIX"
from the menu with the
Jog key.
（Currently selected condition）
(RT2)：The amount of opera-
tions when VR is turned to the
left.
1AIL1FLP 2AIL 2AIL1FLP 2AIL2FLP
All the wing control surfaces are
raised and the camber is
decreased (lift decreases)
③ Open the setting screen by
pressing the Jog key.
● Select the setting item
with the Jog key.
＋
● The value is changed by
+ key or ‒ key.
● When condition is used, the dis-
play can be switched and each
connection can be set by switch-
ing the condition switch.
● Sets the ON/OFF direction of
the selected switch.
(GLIDER)
−