Ext-Voltage Alarm Set Up - FUTABA T6K-V2 Instruction Manual

● EXT-Voltage alarm set up
This setting will sound an alarm when the EXT-voltage drops dangerously low. VIB (vibration) that
vibrates the transmitter at the same time can also be set.
Method
Calling the setting screen
① Select "EXT-VOLT" from the teleme-
try screen with the Jog key.
DN (down) shows than an
alarm is generated when
the voltage drops below
the set voltage.
Alarm set
① In the EXT-VOLT screen state, select
(ALARM) from the menu with the
Jog key.
Vibration set
① In the EXT-VOLT screen state, select
(VIB) from the menu with the Jog
key.
Alarm voltage set
① In the EXT-VOLT screen state, se-
lect (LIMIT) from the menu with
the Jog key.
② Open the setting screen by
pressing the Jog key.
② Select the "ACT" by pressing
the + key or ‒ key.
＋ −
or
② Select the "TYP1-TYP3" by
pressing the + key or ‒ key.
＋ −
or
② S e l e c t t h e v o l t a g e b y
pressing the + key or ‒
key.
＋ −
or
"VIB" types
If the following types are selected, the
transmitter will vibrate during the warning.
TYPE 1
TYPE 2
TYPE 3
Selection range：
0.0V-70.0V
● When you want to set 5.0V, press the
+ key and ‒ key simultaneously.
81