Servo Reverse - FUTABA T6K-V2 Instruction Manual

REVERS

Servo reverse

Function
direction an individual servo responds to a
CAUTION
Only the throttle channel (CH3) initial setting is REV (reverse). Thoroughly check the Hi and Low
directions of the engine or motor used and be careful that they do not suddenly run at full speed.
Since the direction of the ailerons of an airplane can be easily mistaken, be very careful.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
To prevent erroneous setting, after the servo reverse screen was called as described above, the channel
will not be selected if the Jog key is not pressed at the left and right.
Channel select
● Select the channel with the
Jog key.
Servo Reverse
① Channel is Select by Jog
key.
Selection range：
CH1-8
For safety, a double setting system is used. When a change is cancelled after the confirmation message is
displayed, the change is not made when moved to another setting item by Jog key.
64
② Select
（1 second）
② NOR or REV is chosen by Jog key.
● The confirmation message "sure?"
blinks on the screen. (Not displayed
if the same as before.)
For CCPM helicopters, be sure to read the
servos.
With the exception of CCPM helicopters, always
complete your servo reversing prior to any other
programming.
may be confusing to determine whether the servo
needs to be reversed or a setting in the function
each specialized function for further details.
"REVERS"
from the menu with the Jog
key.
(Common)
③ Open the setting screen by
pressing the Jog key.
● The currently selected channel
is highlighted.
● Display Reverse/Normal
REV：Reverse
NOR：Normal
（Channel number）
③ Reverse the servo by pressing the
Jog key.
● A con firmation beeping
sounds and the direction of
operation is reversed.