Parameterization Errors; Communication According To Profidrive; General Information - Siemens SINAMICS G150 Operating Instructions Manual

Operation

6.7 Communication according to PROFIdrive

6.6.10

Parameterization errors

If a fault occurs when reading or writing parameters, a popup window containing the cause of
the problem is displayed.
The system displays:
Parameter write error (d)pxxxx.yy:0xnn
and a plain-text explanation of the type of parameterization error.
6.7 Communication according to PROFIdrive
6.7.1

General information

PROFIdrive V4.1 is the PROFIBUS and PROFINET profile for drive technology with a wide
range of applications in production and process automation.
PROFIdrive is independent of the bus system used (PROFIBUS, PROFINET).
Note
PROFINET for drive technology is standardized and described in the following document:
• PROFIBUS Profile PROFIdrive – Profile Drive Technology, Version V4.1, May 2006,
• IEC 61800-7
Controller, Supervisor, and Drive Unit
● Properties of the Controller, Supervisor, and Drive Unit
Table 6- 11
As bus node
Sending messages
Receiving messages
310
PROFIBUS User Organization e. V.
Haid-und-Neu-Straße 7, D-76131 Karlsruhe, http://www.profibus.com
Order Number 3.172, spec. Chp. 6
Properties of the Controller, Supervisor, and Drive Unit
Properties Controller, Supervisor
Active
Permitted without external
request
Possible with no restrictions
Operating Instructions, 03/2012, A5E03263466A
Drive Unit
Passive
Only possible at the request of
the controller
Only receiving and
acknowledging permitted
Converter cabinet units