Commissioning
5.3 Procedure for commissioning via STARTER
Figure 5-7
NOTICE
You must activate PG/PC is the only master on bus if no other master (PC, S7, etc.) is
available on the bus.
Note
Projects can be created and PROFIBUS addresses for the drive objects assigned even if a
PROFIBUS interface has not been installed on the PC.
To prevent bus addresses from being assigned more than once, only the bus addresses
available in the project are proposed.
When required, a manual address entry can also be used to enter an already assigned
address.
⇒ Once you have done this, click OK to confirm the settings and return to the project wizard.
208
Setting the interface - properties
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A