Siemens SINAMICS G150 Operating Instructions Manual page 286

Converter cabinet units 75 kw to 1500 kw

Hide thumbs Also See for SINAMICS G150:

Table of Contents

6.5 Setpoint sources

In the factory setting and after basic commissioning, an input current of 20 mA is equal to the

main setpoint 100% reference speed (p2000), which has been set to the maximum speed

Example: Changing Analog Input 0 from Current to Voltage Input –10 ... +10 V

The change to the analog input must then be stored on the CompactFlash card so that it is

protected in the event of a power failure.

Actual input voltage/current

Analog inputs smoothing time constant

Current referenced input value

Analog inputs type

Analog inputs, characteristic value x1

Analog inputs, characteristic value y1

Analog inputs, characteristic value x2

Analog inputs, characteristic value y2

Analog inputs offset

Example: setting analog input 0

Current / voltage switchover

Set current/voltage selector to "Voltage" ("V").

Set analog input type 0 to -10 ... +10 V.

Converter cabinet units

Operating Instructions, 03/2012, A5E03263466A