Resetting URL names registered as link destinations
msh> web "ID" clear name
Specify "1" or "2" for ID as the number corresponding to the link name.
Help URL Configuration
You can set URLs linked by clicking "?" on Web Image Monitor.
msh> web help http://"Help URL or IP address"/help/
Resetting Help URL
msh> web clear help
wins
Use the "wins" command to configure WINS server settings.
Viewing settings
msh> wins
• If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address
is the valid address.
Configuration
msh> wins "interface_name" {on|off}
• {on} means "active" and {off} means "inactive".
• Be sure to specify the interface.
Interface name
ether
Address configuration
Use the following command to configure a WINS server IP address:
wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure a primary WINS server IP address.
• Use the "secondary" command to configure a secondary WINS server IP address.
• Do not use "255.255.255.255" as the IP address.
NBT (NetBIOS over TCP/IP) Scope ID Selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "scope ID"
• The scope ID can be entered using up to 31 alphanumeric characters.
Remote Maintenance by telnet
Interface configured
Ethernet interface
5
207