Table of Contents
Advertisement
msh> 8021x imca {on|off}
• You can enable or disable the certificate when the intermediate certificate authority is present.
The default is "off".
msh> 8021x srvid "character string"
• You can set the server ID and subdomain of the certificate server.
• Usable characters: ASCII 0x20-0x7e (128 bytes). The default is blank.
msh> 8021x subdomain
• You can specify permissions for the subdomain.
msh> 8021x clear {a each command|all}
• Returns the selected setting to its default value.
• If you specify "all", all settings will be restored to their default values. However, IEEE 802.1x
Auth. status (enable or disable) for Ethernet will not be initialized.
access
Use the "access" command to view and configure access control. You can also specify two or more access
ranges.
View settings
msh> access
IPv4 configuration display
msh> access ID range
IPv6 configuration display
msh> access ID range6
IPv6 access mask configuration display
msh> access ID mask6
IPv4 configuration
msh> access ID range "start-address end-address"
Example: to specify accessible IPv4 addresses between 192.168.0.10 and 192.168.0.20:
msh> access 1 range 192.168.0.10 192.168.0.20
IPv6 configuration
msh> access ID range6 "start-address end-address"
Example: to specify accessible IPv6 addresses between 2001:DB8::100 and 2001:DB8::200.
msh> access 1 range6 2001:DB8::100 2001:DB8::200
Remote Maintenance by telnet
5
177
Advertisement
Table of Contents
