Table of Contents
Advertisement
View settings
msh> sntp
NTP IPv4 server address configuration
You can specify the IPv4 address of the NTP server.
msh> sntp server "IPv4_address"
NTP hostname configuration
You can specify the hostname of the NTP server.
msh> sntp server "hostname"
Deleting NTP server configuration
msh> sntp server clear
Interval configuration
msh> sntp interval "polling_time"
• You can specify the interval at which the printer synchronizes with the operator-specified NTP
server. The default is 60 minutes.
• The interval can be entered from 0, or between 15 and 10,080 minutes.
• If you set 0, the printer synchronizes with the NTP server only when you turn the printer on. After
that, the printer does not synchronize with the NTP server.
Time-zone configuration
msh> sntp timezone "±hour_time"
• You can specify the time difference between the printer clock and NTP server clock. The values
are between -12:00 and +13:00.
• You can only select either the address or host name for the ntp server.
spoolsw
Use the "spoolsw" command to view and configure Job Spool settings.
You can only specify diprint, trap, lpr, ipp, ftp, sftp, wsd (printer), and smb (TCP/IP) protocol.
• The "spoolsw" command for configuring Job Spool settings is available only when the optional hard
disk is installed.
View settings
The Job Spool setting appears.
msh> spoolsw
Remote Maintenance by telnet
5
203
Advertisement
Table of Contents
