• The same gateway address is shared by all interfaces.
• "Prefixlen" is a number between 1 and 128.
rhpp
Use the "rhpp" command to view and configure RHPP settings.
View settings
msh> rhpp
Changing rhpp port number
msh> rhpp [1024-65535]
• The default is 59100.
Setting timeout
msh> rhpp timeout [30-65535]
• The default is 300 seconds.
• "RHPP" is an abbreviation of "Reliable Host Printing Protocol", which is a manufacturer-original printing
protocol.
set
Use the "set" command to set the protocol information display "active" or "inactive".
View settings
The following command displays protocol information (active/inactive).
msh> set ipv4
msh> set ipv6
msh> set ipsec
msh> set appletalk
msh> set netware
msh> set smb
msh> set protocol
• When protocol is specified, information about TCP/IP, AppleTalk, NetWare and SMB appears.
msh> set lpr
msh> set lpr6
msh> set ftp
Remote Maintenance by telnet
5
195