Paper Size/Type Mismatch - Xerox DP N24 System Administrator Manual

Automatic Tray Switching
Paper Size/Type
Mismatch
2-22 DP N24, N32 and N40 System Administrator Guide
Paper size/type mismatch occurs when the requested size is not
available in the printer. This can be caused by running out of paper
in a tray that is configured for the requested paper, or by requesting
a paper that is not configured in the printer. The printer goes off-line
under paper mismatch conditions. It automatically returns on-line
and continues printing after the paper mismatch condition is
resolved.
If a tray is configured for the requested paper, but the tray is out of
paper, the display prompts you to load the requested paper (size and
type) in the appropriate tray. After the tray is loaded, printing
continues.
If the request is for paper that is not configured in the printer, you
are prompted to load the requested paper in the first tray of the Tray
Sequence setting.
If you do not want to load paper in the first tray of the Tray
Sequence setting, two options are available:
• One of the trays may be loaded with the requested size paper
and reconfigured via the Tray Menu to match the requested
paper type. (See Table 3.7 on page 3-21 for instructions on
using the Tray Menu.)
• Value Up or Value Down
through all the trays, displaying the size and type paper in each
tray. If one of these alternate papers is acceptable, pressing
Enter will cause printing to continue on the new paper.
Trays are searched in the order specified in the Tray Sequence
setting.
may be pressed to scroll