Xerox DP N24 System Administrator Manual page 123

Table 3.13 Ethernet Menu functions (continued)
Menu Item and Function
Default Gateway
Set the four byte Default Gateway
address. The available values are:
xxx.xxx.xxx.xxx
.
Where xxx = 000 to 255
This item only appears if IP Address Res. is
Control Panel
set to
For this item (after Step 3), Item Up
moves the cursor to the right through the
displayed Default Gateway address and
Item Down moves the cursor to the
left. This allows you to change characters
within the string rather than having to
reenter the entire string.
With the cursor displayed under a
character, Value Up increments the
value of that character and Value
Down decrements the value.
1. Press Menu Up
Down
2. Press Item Up
Down
3. Press Value Up
.
Down
4. Press Value Up
Down
the character above the cursor. The
value is incremented or
decremented by 1 each time the
key is pressed. Holding down
Value Up
causes continuous scrolling
through the values.
5. To change other characters in the
Default Gateway address, press
Item Up
to scroll right or left respectively
through the character string, then
press Value Up
Down
the character above the cursor (as
in Step 4).
6. When you have completed setting
theDefault Gateway address, press
Enter
7. Press On Line
Keystrokes
or Menu
M e n u s
until you see:
E t h e r n e t M e n u
or Item
E t h e r n e t M e n u
until you see:
D e f a u l t G a t e w a y
or Value
D e f a u l t G a t e w a y =
. You will see:
xxx.xxx.xxx.xxx
or Value
D e f a u l t G a t e w a y =
to change the value of
xxx.xxx.xxx.xxx
or Value Down
D e f a u l t G a t e w a y =
xxx.xxx.xxx.xxx
or Item Down
or Value
to change the value of
E t h e r n e t M e n u
D e f a u l t G a t e w a y
. You will see:
. You will see: R e a d y
Chapter 3: Using the Control Panel
Ethernet Menu
Display
Table 3.13 Page 10 of 11
3-59