Xerox DP N24 System Administrator Manual page 299

5 Use the screw driver/nut driver to remove the
two screws holding the cover plate on the
controller board as illustrated. Set the screws
and the cover plate aside.
These screws are the same as the screws
packed with the NIC. You will not need the
cover plate when the NIC is installed but
you should keep it in a safe place in case
you remove the card in the future.
6 Insert the NIC into the controller board as
illustrated.
Align the 96 pin connector on the rear
underside of the card with the 96 pin
receptacle in the controller board. Align
the screw receptacles on the front edge of
the NIC with the screw slots on the front of
the controller board.
Appendix C: Installing and Removing Printer Options
Network Interface Card (NIC)
C-51