Xerox DP N24 System Administrator Manual page 180

Control Panel Messages
Table 6.2 Control Panel messages and corrective actions (continued)
Message
†
0 0 0 6 -COMM
† Appears in the upper left corner
of the display.
†
0 0 0 7 -ASIC
† Appears in the upper left corner
of the display.
†
0 0 0 8 -DMA
† Appears in the upper left corner
of the display.
†
0 0 0 9 -ROM BOARD
† Appears in the upper left corner
of the display.
†
0 0 1 0 -DISK
† Appears in the upper left corner
of the display.
†
0 0 4 0
† Appears in the upper left corner
of the display.
†
0 1 0 1
† Appears in the upper left corner
of the display.
6-6 DP N24, N32 and N40 System Administrator Guide
Description/Corrective Action
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred in SIMM1.
ACTION: If there is a memory SIMM in slot SIM1 remove it. Move the memory
SIMM in slot SIM2 into SIM1, then test the printer again. If code 0101
is displayed at power ON, replace the SIMM. If code 0101 is not
displayed at power ON, move the SIMM back to SIM2 and test the
printer again. If code 0101 again displays at power ON, contact your
dealer or Olivetti.
Table 6.2 Page 2 of 19