Fisher FIELDVUE DVC6200 Instruction Manual page 48

Detailed Setup
May 2013
Table 4‐1. Default Detailed Setup Parameters (continued)
Setup Parameter
Cycle Counter Alert Enable
Cycle Counter Alert Deadband
Cycle Counter Alert Point
Travel History Alerts
Travel Accumulator Alert Enable
Travel Accumulator Deadband
Travel Accumulator Alert Point
Travel Deviation Alert Enable
Travel Deviation Alert Point
Travel Deviation Time
Pressure Deviation Alert Enable
Pressure Deviation Alert Point
Deviation & Other Alerts
Pressure Deviation Alert Time
Drive Signal Alert Enable
Supply Pressure Alert Enable
Supply Pressure Alert Point
Travel Alert Lo Enable
Lo Point
Travel Alert Hi Enable
Hi Point
Travel Alert Lo Lo Enable
Travel Alerts
Lo Lo Point
Travel Alert Hi Hi Enable
Hi Hi Point
Deadband
Shutdown Activated
Electronics Alerts
Non‐Critical NVM Alert Enable
Instrument Time Invalid Enable
Calibration in Progress Enable
Autocalibration in Progress Enable
Diagnostics in Progress Enable
Diagnostics Data Available Enable
Informational Status
Integrator Saturated Hi Enable
Integrator Saturated Lo Enable
Pressure Control Active Enable
Multi‐Drop Alert Enable
Valve Alerts Enable
Failure Alerts Enable
Miscelleneous Alerts Enable
Alert Record
Alert Record has Entries Enable
Alert Record Full Enable
1. The settings listed are for standard factory configuration. DVC6200 instruments can also be ordered with custom configuration
settings. For the default custom settings, refer to the order requisition.
2. If the instrument is shipped mounted on an actuator, these values depend upon the actuator on which the instrument is mounted.
3. U.S. Factory defaults only.
48
(1)
Default Setting
No
1%
1000000
No
1%
1000000
Yes
5%
9.99 sec
Yes
(3)
5 psi
9.99 sec
Yes
Yes
(3)
19 psi
No
-25%
No
125%
No
-25%
No
125%
5%
Yes
No
Yes
No
No
No
Yes
Yes
Yes
Yes
No
Yes
Yes
No
Yes
Yes
Instruction Manual
D103409X012