Garmin G3X Installation Manual page 83

GDU 45X Panel Cutout Drawing
190-01115-01
Revision AA
IMPORTANT!
Ensure the Page Scaling setting
is set to NONE when printing
this page. Verify dimensions
of printed template are
accurate before cutting panel.
For corner holes, center punch and drill
(#36) / tap (6/32) to create threaded holes
OR
drill out with #25 drill bit and use Garmin
nut-plate P/N 115-01725-00.
The outline in this drawing is identical
to the outline of the actual bezel.
Cut out panel
to inside line
(4X) .29 in (4X) .29 in
[7.4 mm] [7.4 mm]
5.39 in 5.39 in
[137.0 mm] [137.0 mm]
7.46 in 7.46 in
[189.5 mm] [189.5 mm]
(4X) R .29 in (4X) R .29 in
[7.4 mm] [7.4 mm]
(4X) .29 in (4X) .29 in
[7.4 mm] [7.4 mm]
Figure 7-6 GDU 45X Panel Cutout Drawing
G3X/G3X Touch Installation Manual - GDU 45X Installation
Page 7-8