Garmin G3X Installation Manual page 783

34.2.6 GSA 28
34.2.6.1 GSA 28 is removed
No additional action is required when a GSA 28 is reinstalled or replaced. The correct GSA 28 software
version and autopilot configuration settings will automatically be loaded from the GDU.
NOTE
A removal adapter (GPN 011-03158-00) is provided (with each GSA 28 connector kit) that
can be used when a GSA 28 is removed. The adapter keeps that node on the CAN bus in
the same state as when the servo was connected (either terminated or un-terminated). The
adapter also allows trim signals to pass through when the servo is removed.
34.2.7 GAD 29
No additional action is required when a GAD 29 is reinstalled or replaced. The correct GAD 29 software
version and ARINC 429 configuration will automatically be loaded from the GDU.
34.2.8 GMC 30X
No additional action is required when a GMC 30X is reinstalled or replaced.
190-01115-01
Rev. AA
G3X/G3X Touch Installation Manual - Maintenance
Page 34-7