Garmin G3X Installation Manual page 725

32.4.23 Data Link Configuration Page
The Data Link Configuration Page is only displayed when the unit is configured to communicate with and
has successfully communicated with a GDL 39 (see
Aircraft Type should be set to "Not Pressurized". The Mode S Address field is displayed (and is editable)
if configured for a Mode S Transponder or not configured for any transponder. The Mode S Address field
is not displayed if configured for a non-Mode S Transponder, such as a GTX 327.
1. In configuration mode, use the Touch Panel or a Move Selector Knob to select the Data Link
Configuration Page.
2. Use the Touch Panel or a Move Selector Knob to select the desired configurable item and make the
desired change.
3. Enter data (where applicable) using the Keyboard
4. Press the Back key to return to the Configuration Mode page when finished (if desired).
190-01115-01 G3X/G3X Touch Install Manual - GDU 45X/46X Config and Post Install Checkout
Rev. AA
Section 24.2) for interface and configuration info).
(Section 32.4.1) or Slider Bar (Section 32.4.2).
Page 32-130