Configuring Routing Between An Mce And A Vpn Site - HP HSR6800 Configuration Manual

Configuring routing between an MCE and a VPN site

You can configure static routing, RIPng, OSPFv3, IPv6 IS-IS, or EBGP between an MCE and a VPN
site.
Configuring static routing between an MCE and a VPN site
An MCE can reach a VPN site through an IPv6 static route. IPv6 static routing on a traditional CE is
globally effective and thus does not support address overlapping among VPNs. An MCE supports
binding an IPv6 static route with an IPv6 VPN instance, so that the IPv6 static routes of different IPv6
VPN instances can be isolated from each other.
To configure IPv6 static routing between an MCE and a VPN site:
Step
1. Enter system view.
2. Configure an IPv6
static route for an IPv6
VPN instance.
Configuring RIPng between an MCE and a VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
VPNs to be exchanged between the MCE and the sites through different RIPng processes, ensuring
the separation and security of IPv6 VPN routes.
To configure RIPng between an MCE and a VPN site:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter
RIPng view.
3. Redistribute remote site
routes advertised by the PE.
4. Configure the default cost
value for the redistributed
routes.
5. Return to system view.
6. Enter interface view.
Command
system-view
•
ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name
nexthop-address } [ preference
preference-value ]
•
ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6> ipv6-address
prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address
[ public ] | vpn-instance d-vpn-instance-name
nexthop-address } [ preference
preference-value ]
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | route-policy
route-policy-name ] *
default cost value
quit
interface interface-type
interface-number
395
Remarks
N/A
Use either command
as needed.
Perform this
configuration on the
MCE. On a VPN site,
configure normal
IPv6 static routes.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
By default, no route of any other
routing protocol is redistributed
into RIPng.
Optional.
0 by default.
N/A
N/A