Configuring Routing Between A Pe And A Ce - HP HSR6800 Configuration Manual

NOTE:
• A tunneling policy configured in VPN instance view is applicable to both IPv4 VPNs and IPv6
VPNs.
• You can configure a tunneling policy for IPv4 VPNs in both VPN instance view and IPv4 VPN
view. A tunneling policy configured in IPv4 VPN view takes precedence.
Configuring an LDP instance
LDP instances are for carrier's carrier network applications.
This task is to configure the LDP capability for an existing VPN instance, create an LDP instance for
the VPN instance, and configure LDP parameters for the LDP instance.
To configure an LDP instance:
Step
1. Enter system view.
2. Enable LDP for a VPN
instance, create an LDP
instance, and enter MPLS
LDP VPN instance view.
3. Configure LDP parameters
except LDP GR for the
instance.
Except the command for LDP GR, all commands available in MPLS LDP view can be configured in
MPLS LDP VPN instance view. For more information about MPLS LDP, see "Configuring basic
MPLS."
Configurations in MPLS LDP VPN instance view affect only the LDP-enabled interface bound to the
VPN instance. Configurations in MPLS LDP view do not affect interfaces bound to VPN instances.
When configuring the transport address of an LDP instance, use the IP address of the interface
bound to the VPN instance.
By default, LDP adjacencies on a private network are established by using the addresses of the
LDP-enabled interfaces, and those on the public network are established by using the LDP LSR ID.

Configuring routing between a PE and a CE

You can configure static routing, RIP, OSPF, IS-IS, EBGP, or IBGP between a PE and a CE.
Before you configure routing between a PE and a CE, complete the following tasks:
•
Assign an IP address to the CE-PE interface of the CE.
•
Assign an IP address to the PE-CE interface of the PE.
Configuring static routing between a PE and a CE
Step
1. Enter system view.
Command
system-view
mpls ldp vpn-instance
vpn-instance-name
For configuration information, see
"Configuring basic MPLS."
Command
system-view
265
Remarks
N/A
Disabled by default.
Optional.
Remarks
N/A