HP HSR6800 Configuration Manual page 404

Step
7. Enable RIPng on the
interface.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
Configuring OSPFv3 between an MCE and a VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public
network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of
different IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3
processes, ensuring the separation and security of IPv6 VPN routes.
To configure OSPFv3 between an MCE and a VPN site:
Step
1. Enter system view.
2. Create an OSPFv3 process
for a VPN instance and enter
OSPFv3 view.
3. Set the router ID.
4. Redistribute remote site
routes advertised by the PE.
5. Return to system view.
6. Enter interface view.
7. Enable OSPFv3 on the
interface.
NOTE:
Deleting a VPN instance also deletes all related OSPFv3 processes at the same time.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
Configuring IPv6 IS-IS between an MCE and a VPN site
An IPv6 IS-IS process belongs to the public network or a single IPv6 VPN instance. If you create an
IPv6 IS-IS process without binding it to an IPv6 VPN instance, the process belongs to the public
network.
By configuring IPv6 IS-IS process-to-IPv6 VPN instance bindings on a MCE, you allow routes of
different IPv6 VPNs to be exchanged between the MCE and the sites through different IPv6 IS-IS
processes, ensuring the separation and security of IPv6 VPN routes.
To configure IPv6 IS-IS between an MCE and a VPN site:
Step
1. Enter system view.
2. Create an IPv6 IS-IS
process for a VPN instance
and enter IS-IS view.
Command
ripng process-id enable
Command
system-view
ospfv3 [ process-id ]
vpn-instance vpn-instance-name
router-id router-id
import-route protocol
[ process-id | allow-ibgp ] [ cost
value | route-policy
route-policy-name | type type ] *
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
396
Remarks
Disabled by default.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal OSPFv3.
N/A
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
N/A
N/A
By default, OSPFv3 is disabled on
an interface.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal IPv6 IS-IS.