Configuring Routing Between Ipv6 Mce And Vpn Site - HP MSR2000 series Configuration Manual

Configuring routing between IPv6 MCE and VPN site

Configuring static routing between IPv6 MCE and VPN site
An IPv6 MCE can reach a VPN site through an IPv6 static route. IPv6 static routing on a traditional CE
is globally effective and thus does not support address overlapping among VPNs. An IPv6 MCE supports
binding an IPv6 static route with an IPv6 VPN instance, so that the IPv6 static routes of different IPv6 VPN
instances can be isolated from each other.
To configure IPv6 static routing between IPv6 MCE and VPN site:
Step
1. Enter system view.
2. Configure an IPv6 static route
for an IPv6 VPN instance.
Configuring RIPng between IPv6 MCE and VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on an IPv6 MCE, you allow routes of different
VPNs to be exchanged between the IPv6 MCE and the sites through different RIPng processes, ensuring
the separation and security of IPv6 VPN routes.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between IPv6 MCE and VPN site:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
3. Redistribute remote site routes
advertised by the PE.
Command
system-view
•
ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name
nexthop-address } [ preference
preference-value ]
•
ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6> ipv6-address
prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address }
[ preference preference-value ]
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
421
Remarks
N/A
Use either command.
Perform this
configuration on the
IPv6 MCE. On a VPN
site, configure normal
IPv6 static routes.
Remarks
N/A
Perform this configuration on the
IPv6 MCE. On a VPN site,
configure normal RIPng.
By default, no route of any other
routing protocol is redistributed
into RIPng.