Vpls Configuration Task List; Enabling L2Vpn And Mpls L2Vpn - HP HSR6800 Configuration Manual

Figure 58 Diagram for multi-hop PW
As shown in
and PE 2, perform the following tasks:
•
Establish three PWs: PW 1 between PE 1 and ASBR 1, PW 2 between ASBR 1 and ASBR 2,
and PW 3 between ASBR 2 between PE 2.
•
Associate PW 1 and PW 2 on ASBR 1. Then, when receiving a packet from PW 1 (or PW 2),
ASBR 1 removes the existing inner and outer labels of the packet and adds the inner and outer
labels of PW 2 (or PW 1) to the packet.
•
Associate PW 2 and PW 3 on ASBR 2. Then, upon receiving a packet from PW 2 (or PW 3),
ASBR 2 removes the existing inner and outer labels of the packet and then adds the inner and
outer labels of PW 3 (or PW 2) to the packet.
Thus, PW 1, PW 2, and PW 3 are put end to end and a multi-hop PW is formed across the ASs.
NOTE:
Only LDP VPLS connections can form a multi-hop PW.

VPLS configuration task list

Task

Enabling L2VPN and MPLS L2VPN

Configuring static VPLS
Configuring LDP VPLS
Configuring BGP VPLS
Binding a VPLS instance
Configuring MAC address learning
Configuring VPLS instance attributes
Enabling L2VPN and MPLS L2VPN
Enable L2VPN and MPLS L2VPN before you perform VPLS-related configurations.
Figure 58, PE 1 and PE 2 are in different ASs. To set up a multi-hop PW between PE 1
Remarks
Required.
Configure one type of VPLS as
needed.
Required.
Optional.
Optional.
203