HP HSR6800 Configuration Manual page 421

[PE1-bgp-ipv6-vpn1] import-route direct
[PE1-bgp-ipv6-vpn1] quit
[PE1-bgp] quit
# Configure CE 2 and PE 2 in a similar way to configuring CE 1 and PE 1. (Details not shown.)
After completing the configurations, execute the display bgp vpnv6 vpn-instance peer
command on the PEs. BGP peer relationships have been established between PEs and CEs,
and have reached Established state.
Take PE 1 as an example:
[PE1] display bgp vpnv6 vpn-instance vpn1 peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1
Peer
2001:1::1
5. Configure an MP-IBGP peer relationship between the PEs:
# Configure PE 1.
[PE1] bgp 100
[PE1-bgp] peer 2.2.2.9 as-number 100
[PE1-bgp] peer 2.2.2.9 connect-interface loopback 0
[PE1-bgp] ipv6-family vpnv6
[PE1-bgp-af-vpnv6] peer 2.2.2.9 enable
[PE1-bgp-af-vpnv6] quit
[PE1-bgp] quit
# Configure PE 2 in a similar way to configuring PE 1. (Details not shown.)
After completing the configuration, execute the display bgp peer command or the display bgp
vpnv6 all peer command on the PEs. A BGP peer relationship has been established between
the PEs, and has reached Established state.
[PE1] display bgp vpnv6 all peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1
Peer
2.2.2.9
6. Configure a GRE tunnel:
# Configure PE 1.
[PE1] interface tunnel 0
[PE1-Tunnel0] tunnel-protocol gre
[PE1-Tunnel0] source loopback 0
[PE1-Tunnel0] destination 2.2.2.9
[PE1-Tunnel0] ip address 20.1.1.1 24
[PE1-Tunnel0] mpls
[PE1-Tunnel0] quit
# Configure PE 2.
[PE2] interface tunnel 0
[PE2-Tunnel0] tunnel-protocol gre
[PE2-Tunnel0] source loopback 0
[PE2-Tunnel0] destination 1.1.1.9
[PE2-Tunnel0] ip address 20.1.1.2 24
AS MsgRcvd MsgSent
65410 5
AS MsgRcvd MsgSent
100 3
413
Peers in established state : 1
OutQ PrefRcv
5 0
Peers in established state : 1
OutQ PrefRcv Up/Down
3 0 1
Up/Down State
1 00:02:03 Established
State
00:00:34 Established