HP HSR6800 Configuration Manual page 197

After configuration, you can execute the display mpls ldp session and display mpls ldp peer
commands to view the LDP sessions and peer relationship established, or the display mpls
lsp command to view the LSPs established.
3. Configure BGP L2VPN capability:
# Configure PE 1.
<Sysname> system-view
[Sysname] sysname PE1
[PE1] l2vpn
[PE1-l2vpn] mpls l2vpn
[PE1-l2vpn] quit
[PE1] bgp 100
[PE1-bgp] peer 3.3.3.9 as-number 100
[PE1-bgp] peer 3.3.3.9 connect-interface loopback 0
[PE1-bgp] l2vpn-family
[PE1-bgp-af-l2vpn] policy vpn-target
[PE1-bgp-af-l2vpn] peer 3.3.3.9 enable
[PE1-bgp-af-l2vpn] quit
[PE1-bgp] quit
# Configure PE 2.
<Sysname> system-view
[Sysname] sysname PE2
[PE2] l2vpn
[PE2-l2vpn] mpls l2vpn
[PE2-l2vpn] quit
[PE2] bgp 100
[PE2-bgp] peer 1.1.1.9 as-number 100
[PE2-bgp] peer 1.1.1.9 connect-interface loopback 0
[PE2-bgp] l2vpn-family
[PE2-bgp-af-l2vpn] policy vpn-target
[PE2-bgp-af-l2vpn] peer 1.1.1.9 enable
[PE2-bgp-af-l2vpn] quit
[PE2-bgp] quit
After completing the configurations, execute the display bgp l2vpn peer command on PE 1
and PE 2 to view the peer relationship established between the PEs. The peer state should be
Established. Take PE 1 as an example:
[PE1] display bgp l2vpn peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1
Peer V
3.3.3.9 4
4. Configure the L2VPN and the CE connection:
# Configure PE 1.
[PE1] mpls l2vpn vpn1 encapsulation ppp
[PE1-mpls-l2vpn-vpn1] route-distinguisher 100:1
[PE1-mpls-l2vpn-vpn1] vpn-target 1:1
[PE1-mpls-l2vpn-vpn1] ce ce1 id 1 range 10
[PE1-mpls-l2vpn-ce-vpn1-ce1] connection ce-offset 2 interface serial 2/1/0
[PE1-mpls-l2vpn-ce-vpn1-ce1] quit
AS MsgRcvd MsgSent
100 2
189
Peers in established state : 1
OutQ PrefRcv Up/Down
5 0 0 00:01:07 Established
State