HP HSR6800 Configuration Manual page 233

[UPE-GigabitEthernet2/1/1] l2 binding vsi aaa
[UPE-GigabitEthernet2/1/1] quit
# Bind the VPLS instance aaa to GigabitEthernet 2/1/2, the interface connected to CE 2.
[UPE] interface gigabitethernet 2/1/2
[UPE-GigabitEthernet2/1/2] l2 binding vsi aaa
[UPE-GigabitEthernet2/1/2] quit
3. Configure NPE 1:
# Configure basic MPLS.
<Sysname> system-view
[Sysname] sysname NPE1
[NPE1] interface loopback 0
[NPE1-LoopBack0] ip address 2.2.2.2 32
[NPE1-LoopBack0] quit
[NPE1] mpls lsr-id 2.2.2.2
[NPE1] mpls
[NPE1–mpls] quit
[NPE1] mpls ldp
[NPE1–mpls-ldp] quit
# Configure an IP address for the interface connected to UPE, and enable MPLS and MPLS
LDP.
[NPE1] interface gigabitethernet 2/1/1
[NPE1-GigabitEthernet2/1/1] ip address 12.1.1.2 24
[NPE1-GigabitEthernet2/1/1] mpls
[NPE1-GigabitEthernet2/1/1] mpls ldp
[NPE1-GigabitEthernet2/1/1] quit
# Configure an IP address for the interface connected to NPE 3, and enable MPLS and MPLS
LDP.
[NPE1] interface gigabitethernet 2/1/2
[NPE1-GigabitEthernet2/1/2] ip address 15.1.1.1 24
[NPE1-GigabitEthernet2/1/2] mpls
[NPE1-GigabitEthernet2/1/2] mpls ldp
[NPE1-GigabitEthernet2/1/2] quit
# Configure the remote LDP peer UPE.
[NPE1] mpls ldp remote-peer 2
[NPE1-mpls-remote-2] remote-ip 1.1.1.1
[NPE1-mpls-remote-2] quit
# Configure the remote LDP peer NPE 3.
[NPE1] mpls ldp remote-peer 3
[NPE1-mpls-remote-3] remote-ip 4.4.4.4
[NPE1-mpls-remote-3] quit
# Enable L2VPN and MPLS L2VPN.
[NPE1] l2vpn
[NPE1-l2vpn] mpls l2vpn
[NPE1-l2vpn] quit
# Create VPLS instance aaa that uses LDP signaling.
[NPE1] vsi aaa static
[NPE1-vsi-aaa] pwsignal ldp
[NPE1-vsi-aaa-ldp] vsi-id 500
225