HP HSR6800 Configuration Manual page 229

[UPE-LoopBack0] quit
[UPE] mpls lsr-id 1.1.1.9
[UPE] mpls
[UPE-mpls] quit
[UPE] mpls ldp
[UPE-mpls-ldp] quit
# Configure basic MPLS on GigabitEthernet 2/1/2, the interface connected to NPE 1.
[UPE] interface gigabitethernet 2/1/2
[UPE-GigabitEthernet2/1/2] ip address 10.1.1.1 24
[UPE-GigabitEthernet2/1/2] mpls
[UPE-GigabitEthernet2/1/2] mpls ldp
[UPE-GigabitEthernet2/1/2] quit
# Configure the remote LDP peer.
[UPE] mpls ldp remote-peer 1
[UPE-mpls-remote-1] remote-ip 2.2.2.9
[UPE-mpls-remote-1] quit
# Enable L2VPN and MPLS L2VPN.
[UPE] l2vpn
[UPE-l2vpn] mpls l2vpn
[UPE-l2vpn] quit
# Create VPLS instance aaa that uses LDP signaling.
[UPE] vsi aaa static
[UPE-vsi-aaa] pwsignal ldp
[UPE-vsi-aaa-ldp] vsi-id 500
[UPE-vsi-aaa-ldp] peer 2.2.2.9
[UPE-vsi-aaa-ldp] quit
[UPE-vsi-aaa] quit
# Configure interface GigabitEthernet 2/1/1 and bind VPLS instance aaa to the interface.
[UPE] interface gigabitethernet 2/1/1
[UPE-GigabitEthernet2/1/1] l2 binding vsi aaa
[UPE-GigabitEthernet2/1/1] quit
3. Configure NPE 1:
# Configure basic MPLS.
<Sysname> system-view
[Sysname] sysname NPE1
[NPE1] interface loopback 0
[NPE1-LoopBack0] ip address 2.2.2.9 32
[NPE1-LoopBack0] quit
[NPE1] mpls lsr-id 2.2.2.9
[NPE1] mpls
[NPE1–mpls] quit
[NPE1] mpls ldp
[NPE1–mpls-ldp] quit
# Configure basic MPLS on GigabitEthernet 2/1/1, the interface connected to UPE.
[NPE1] interface gigabitethernet 2/1/1
[NPE1-GigabitEthernet2/1/1] ip address 10.1.1.2 24
[NPE1-GigabitEthernet2/1/1] mpls
[NPE1-GigabitEthernet2/1/1] mpls ldp
221