Inserting Media Modules - Avaya G450 Quick Start For Hardware Installation

Result
Danger:
To prevent access to electrical hazards by unauthorized personnel and to ensure continued
compliance to radiated emissions requirements, all captive screws must be securely
tightened such that they cannot be loosened without the use of a tool.

Inserting media modules

After you have inserted the S8300 Server module, if applicable, insert the rest of the media
modules. Make sure to insert each module in a permissible slot. Remove the blank plate from
the empty bay.
Electrostatic alert:
Hold media modules only by the edges to avoid damage from static electricity. Do not touch
the top or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-static
bag.
Caution:
The connector pins can be bent or damaged if the module is handled roughly, or if misaligned
and then forced into position.
Caution:
Separate ESD paths to the chassis ground connect to the media modules at the spring-
loaded captive screws. Use a screwdriver to ensure the captive screws are securely
tightened to prevent damage to the equipment.
1. Position the media module before the selected bay on the front of the Branch
2. Slide the module slowly into the chassis, maintaining an even pressure to assure
Quick Start for Hardware Installation: Avaya G450 Branch Gateway
Make sure to insert each module in a permissible slot.
Gateway chassis and engage both sides of the module in the interior guides.
that the module does not become twisted or disengaged from the guides.
Installing the media modules
February 2011 31