Avaya G450 Quick Start For Hardware Installation page 38

Prepare for configuration
3. Connect the laptop computer to the Branch Gateway Services port, using an
4. SSH to 192.11.13.6.
5. At the prompt, enter the default username: root and password: rootroot0.
6. At the prompt, configure a new password.
7. At the prompt, enter y to configure basic gateway connectivity.
8. You are prompted to configure the following parameters.
38 Quick Start for Hardware Installation: Avaya G450 Branch Gateway
• IP address: 192.11.13.5
• Subnet mask: 255.255.255.252
• Disable DNS service
• Disable WINS Resolution
Ethernet cable.
Note:
If you enter n but then change your mind, you can use the script-config CLI
command to run the installation script, so long as you have not saved any
configuration changes you may have made.
For each parameter, you can enter a value, or press Enter to accept the default
value shown in square brackets:
• VLAN number
• IPv4 enabled or disabled
• IPv4 address for the primary management interface
• IPv4 Subnet mask for the primary management interface
• IPv4 address for the default gateway (router)
• IPv6 enabled or disabled
• IPv6 Unicast global address.
• IPv6 prefix length
• IPv6 Link local address
• IPv6 PMI (Global or Link Local)
• IPv6 Default gateway
• Up to eight IP addresses (four IPv4 and four IPv6) to specify the Media
Gateway Controllers
• Hostname for the Branch Gateway
The settings you configured are displayed, and you are prompted for
confirmation.
• If you confirm the settings, they are saved and the Branch Gateway reboots.
February 2011