Avaya G450 Quick Start For Hardware Installation page 30

Install media modules
Electrostatic alert:
Hold the module only by its edges to avoid damage from static electricity. Do not touch the
top or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-static
bag.
Caution:
The connector pins can be bent or damaged if the module is handled roughly, or if misaligned
and then forced into position.
Caution:
Separate ESD paths to the chassis ground connect to the media modules at the spring-
loaded captive screws. Use a screwdriver to ensure the captive screws are securely
tightened to prevent damage to the equipment.
1. If you are installing an S8300, remove the plate above slot V1
2. Remove the blank plate from slot V1.
3. Position the server before the V1 bay opening and engage both sides of the module
4. Slide the S8300 Server slowly into the chassis, maintaining an even pressure to
5. Apply firm pressure to engage the connectors.
6. Lock the S8300 Server module into the chassis by tightening the spring-loaded
7. After you have inserted the S8300 Server module, if applicable, insert the rest of
30 Quick Start for Hardware Installation: Avaya G450 Branch Gateway
in the interior guides.
assure that the module does not become twisted or disengaged from the guides.
Figure 3: Inserting the S8300 Server
The connector has pins of different lengths. The long pins engage first to provide
grounding. Medium length and short pins provide power and signal.
captive screws on the front of the module.
If you are installing an S8300, replace the plate labelled "Remove before removing
or inserting S8300 module" above slot V1 and tighten the screws on the front of the
plate.
the media modules.
February 2011