Chapter 4: Install media modules
Installing the media modules
When the Branch Gateway chassis is installed and the power supply unit(s) have been
inserted, you can insert the media modules. Each module is shipped with two thumb screws
for securing the module in the Branch Gateway chassis.
Note:
The required media modules are sometimes pre-installed in the Branch Gateway chassis.
If this is the case, skip this step. Read this section only if the media modules are not pre-
installed, or if you want to replace modules or add new media modules.
Before inserting media modules into the Branch Gateway chassis
Combination limitations
Slot allocation
Inserting the S8300 Server
Inserting media modules
Before inserting media modules into the Branch Gateway chassis
• Do not install an unsupported combination of media modules. See
limitations
• Allocate a permissible slot to each media module. See
Warning:
Do not operate the Branch Gateway with any open slots. Failure to cover empty slots with
the supplied blank plates can cause overheating due to inadequate air distribution.
Quick Start for Hardware Installation: Avaya G450 Branch Gateway
Related topics:
on page 28
on page 28
on page 29
on page 31
on page 28.
on page 27
Combination
Slot allocation
on page 28.
February 2011
27